SMC导式2通电磁阀，日本SMC导式电磁阀
ISO ＃ ：根据DIN 43650C （引脚差距8公厘）
2 。卸下紧固螺钉之后，分接线端子
和住房由撬开下部的槽区
接线盒用螺丝刀打开。
3 。松开块的端子螺丝和插入剥离
根据布线图的引线。每个安全
丝通过重新拧紧端子螺丝（在终端的情况下
1 ：（+） ，2： （ - ） DC）
4 。拧紧螺母地面固定电缆线。
更改电气入境
丝条目可以通过安装在外壳任方向被改变
除以终端后（四个方向每90°）
块和所述壳体。
*对于指示器点亮样式，注意不要损坏光
与电缆的导线。
电线外径： ø3.5到O7
（参考）0.5 2芯和3芯线材相当于JIS C
Dust-proof (equivalent to IP40)
Dust-tight (equivalent to IP60) Note 5)
Dust-tight / Low jetproof (equivalent to IP65)
2.5 (VDW10), 3 (VDW20/30)
24 VDC, 12 VDC, 6 VDC, 5 VDC, 3 VDC,
100 VAC, 110 VAC, 200 VAC, 220 VAC (50/60 Hz)
1) When used under conditions which may cause condensation on the exterior of the product,
select Grommet / Molded.
2) When used with deionized water, select “L" (Stainless steel, FKM) for the material type.
3) Since the AC coil specification includes a rectifier element, there is no difference in power consumption
between inrush and holding.
In the case of 110/220 VAC, the VDW10 is 3 W and the VDW20/30 is 3.5 W.
4) Vibration resistance ····· No malfunction when tested with one sweep of 5 to 200 Hz in the axial
direction and at a right angle to the armature, in both energized and
deenergized states.

SMC导式2通电磁阀，日本SMC导式电磁阀